Description
A ceiling T grid, also known as a suspended ceiling grid or drop ceiling grid, is a framework of metal or plastic components used to support ceiling tiles or panels. It consists of main runners, cross tees, and wall angles that are interconnected to create a grid pattern. This grid system provides a stable structure for installing and suspending ceiling tiles, allowing for easy access to the space above the ceiling for maintenance or repairs. Ceiling T grids are commonly used in commercial buildings, offices, schools, and other spaces where a suspended ceiling is desired.
Main Parameters:
- Raw Material: Pre-pained Steel 0.18-0.23mm, Galvanized steel 0.25-0.35mm
- Cross T grid length: 1220mm, 610mm,
- Both metric and imperial products can be produced
- 18 groups of rollers, 1 group straightening
- Forming speed: 0-30m/min
Production Process of Main Tee Bar Roll Forming Machine:
Uncoiler (2 sets)- Roll Forming Machine-Automatic Punching and Cut-off after Forming- Finished Products
Main Components of T grid machine:
I. Decoiler 2 sets
Coil O.D 1200MM
Max. Outer diameter 1200mm
Inner diamter::φ450-530mm
Capacity: 500kgs/ Each Decoiler
Manual tension, with brake device
II. Roll Forming Machine:
Rollers: 18 groups forming rollers with feeding guide, 2 groups straightening device
Worktable : All-in-one structure, made by #45 steel, work table thickness:20mm, side wall 6mm
Material of roller: Cr12 Mov, hardness HRC55°, surface very smooth,will not scratch products
Roller Shaft: 40CR, Quenched and tempered, grinded, φ39
Machine frame structure: Pillar Rack, thickness 38mm, each group equip 8pcs Japan 6206 bearings. Surface with blackened treatment, long-term use and avoid rust
The main machine base is assembled from high-strength steel with precise welding treatment
Forming speed:0-30m/min
Product length: 3600mm
III. Driven Method
Driven by Gear / Chain Optional
IV. Hydraulic Punch and Cut-off
The punch die frame is made of #45 steel, all with fine plates and blacked on the surface
The punching die uses the material of SKD11 with vacuum heat treatment, hardness up to HRC58-60 degree, wear-resistance, good steel structure and long life use.
Punch die inserts can be quickly changed.
The punching die plate uses 50# steel, with fine plate treatment.
The punch unit worktable is a one-piece structure, with a worktable thickness of 20mm, a side thickness of 6mm
The hydraulic pump brand: Taiwan Kaijia
the oil valve: Taiwan Yutien brand
Oil pipes are made of steel wire and equipped with adaptable joints
Motor: 15KW all-copper wire temperature-resistant motor
Non-stop machine Punching the hanging holes and heads at one time.
Hydraulic cooling: Oil Cooling
Punching die:
Head dies | 1 set |
Tail die | 1 set |
Middle hold die | 22 sets |
Main grid High-pressure pipe | 2 pcs |
The safe cover is optional
V. Run-out table
Stainless Run-ou table
VI. Electric control
- Programmable controller 1set
- Industrial HMI 1 set
- Electric voltage: 380v 50Hz 3phase ( need customer confirmation)
Reviews
There are no reviews yet.